When sewer line repairs are needed one can tend to panic, and possibly rush into a hiring decision. This should be an urge to avoid. There are many factors to consider and things a property owner should know before making a hiring decision. Having to spend a substantial amount of money on an unexpected sewer repair or replacement is upsetting. Misspending that money can be even more upsetting. Know the facts before you hire a sewer contractor. Get the most ‘bang for your buck’ and long-term peace of mind when sewer line repairs are needed.
Commercial & Residential Emergencies in NYC
Spot sewer line repairs can vary in price from as low as around $3,000.00 to as high as around $6,000.00. The major factors include the location that has to be excavated and the required depth of the excavation.
To a lesser degree restoration of disturbed surfaces is also a cost factor. Naturally backfilling a hole in a grassy area is far different than backfilling and restoring a city roadway. Roadway restoration on sewer line repairs typically costs around $700.00.
What do you get for your money?
Here are some simple facts regarding sewer line repairs and replacements:
- The average length of run for a house sewer is 45′ in most boroughs of NYC.
- The average spot repair entails replacing less than 10′ of sewer pipe.
- The average spot repair costs 40% to 60% of a complete replacement.
A property owner typically gets less than 25% of their house sewer replaced at 50% of the cost of entire line. In simpler terms, a house sewer relay costs between $200.00 and $300.00 per foot. Spot sewer line repairs cost $300.00 to $600.00 per foot, or almost double the per foot price of a replacement.
Another factor to consider is that if the house sewer becomes defective again in the future, another spot sewer repair would typically be frowned upon. The spot repair that was done would most likely be removed during a full sewer line replacement job, making its original benefits dubious.
What type of sewer line repairs make sense?
There are basically only a few instances when spot sewer line repairs make sense. They key point is being 100% sure that the problem is contained in one small section of the sewer run, and knowing the direction the line runs in. The following three circumstances are the most common:
Sewer pipe is broken in or near the foundation wall
In many cases a house drain transitions from cast iron pipe to clay pipe about 5′ past the foundation wall. This can frequently be the point of a dislodged pipe, or a leaking sewer joint.
Sewer line repairs near a foundation wall are typically the least expensive to perform. This is because the pipe will be at its most shallow point, and typically restoration of finished paving surfaces is not required.
Pipe is broken at or near the connection to city sewer
Another weak point in many house sewer systems is where the connection is made to the city sewer. In most cases a concrete joint must be made because of having to joint two unlike materials – clay and cast iron. Over time the concrete can leak or become porous. This can cause the sub base supporting the pipe to erode. The pipe can then settle or dislodge.
Using a sewer sonde, city sewer records, and a video camera can pinpoint the location of the connection. After the location can be absolutely verified, a repair near the connection can be made with confidence.
A house sewer broken by a known outside event
In some cases an event will occur where it is clearly known why and how the pipe broke. An example would be if another contractor performing work disturbs a house sewer line. This could be done by a fence company installing a pole, a drilling company, or a utility company doing road work.
In these cases a spot repair typically makes perfect sense, and will provide a long-lasting solution. Another good example is if a tree topples over ripping up a section of the house sewer. Since it is a known event, and the location is known as well, the repair can be easily done.
When a spot repair is a bad idea
There are many instances when spot sewer repairs are a bad idea, or simply not cost effective. Some common sewer problems that typically do not lend themselves to repairs are as follows:
- Backpitched sewer lines
- Grease filled sewer lines
- House sewer lines blocked with roots over an extensive portion of the sewer run
- Lines that are corroded by chemicals or old age
- Lines with a bad section that is not accessible due to obstructions such as trees, or utility lines.
Partial sewer line replacements vs. spot sewer line repairs
Partial sewer line replacements and spot sewer line repairs are quite different from each other. Spot sewer line repairs are usually done randomly at a specific trouble spot. On the other hand, a partial replacement ensures that 40% to 60% of the line is completely replaced.
Many times a partial sewer replacement costs only a few hundred dollars more than a spot repair, yet provides many more feet of new pipe. A partial sewer replacement usually falls into two distinct job descriptions:
Partial relay from front of house to the curb line
If a house sewer has a single or multiple problems between the front of the house and the curb a partial sewer replacement can be attempted with little risk. Because a length of the sewer run is being replaced, the exact location of the problem(s) is not so vitally important.
Because the exit point from the house is known, it greatly reduces the chance of excavating in the wrong location. Furthermore, costs involved with exactly locating the problem are eliminated. Once this section of the pipe run is replaced it should last and be maintenance free for decades.
Partial relay from curb line to city sewer in roadway
The other type of partial relay that frequently makes sense is replacing from the curb line to the city connection. This partial replacement would eliminate the need to ever open the roadway again for a sewer problem.
Like other types of sewer line repairs, the location of the connection to the city sewer would have to be verified. This is typically done by obtaining city sewer records. Also an electronic sewer sonde is needed to trace the line and verify the location.
Working the roadway for a partial replacement or spot repair is the most expensive type of sewer work. Like all house sewer work it requires an inspection, but it also involves roadway restoration and NYC DOT roadway opening permits.
A final word about sewer line repairs
In NYC only Licensed Master Plumbers can undertake any type of house sewer work. In addition a bond must be on file with the NYC DOT, and proper insurance in place.
The repair and replacement of sewer lines is a specialty within the NYC plumbing industry, with only a small percentage of firms choosing to provide this service. When work is required it is best to trust a properly licensed and insured specialist.
It is typically best to become knowledgeable about your sewer problem and carefully consider the proper solution. The above post should be used as a helpful guide. Saving money is always a valid issue. However a more important issue may be to spend money wisely on a long-lasting solution.